Description
Specifications
Description
The high efficiency gas furnace may be installed free standing in a utility room, basement, or enclosed in an alcove or closet. The rounded corner jacket provides a pleasing "appliance appearance." Design certified by CSA for application in Canada and the United States.
Standard Features:
- 100% fired and tested: All units and each component are tested on the manufacturing line.
- Best packaging in the industry: Unique corner post design assures product will arrive to the homeowner dent free.
- Low Boy Height: Easy to apply in low ceiling applications, works well with taller high SEER coils, easier to handle and install.
- Tubular primary heat exchanger: Heavy gauge aluminized steel heat exchanger assures a long life.
- 30 second blower delay at start-up: Assures a warm duct temperature at furnace start-up. Adjustable blower off settings (60, 90, 120 and 180 seconds).
- 30 second post purge: Increases life of heat exchanger.
- Hot surface igniter: Innovative application of a silicon nitride type igniter. Utilizes proven Smartlite® technology.
- Color coded wire harness: Designed to fit the components, all with quick-connect fittings for ease of service and replacement.
- High static blowers: All models equipped with high static blowers.
- 90 second cooling cycle blower-off delay (TDR): increases cooling performance when matched with a NORDYNE coil.
- Flexible category I venting system: May be vented with dedicated venting system or common vented with other category one appliances.
- High efficiency blower kits: Maximize efficiencies. On select units, a SEER improvement of up to 1 point is realized.
- Multi-speed direct drive blower: Designed to give a wide range of cooling capacities. Switches on PCB, provide ultra easy motor speed selection.
- LP convertible: Simple burner orifi ce and regulator spring change for ease of convertibility.
- Diagnostic lights for easy troubleshooting without counting flashes: Dedicated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes.
- Integrated control board: Incorporates connections for electronic air cleaner and humidifier.
- Two piece door design: Enhances furnace appearance and uses captured screws to prevent loosing door screws.
- Blower Compartment: Insulated for ultra quiet moderation.
California residents: see Proposition 65 Warning
Documents
picture_as_pdf consumer literature
picture_as_pdf consumer literature
picture_as_pdf consumer literature
picture_as_pdf installation instructions
picture_as_pdf parts list
picture_as_pdf specification sheet
picture_as_pdf warranty document
picture_as_pdf wiring diagrams
Specifications
Weight | 114 |
---|---|
Height | 36 |
Length | 30 |
Width | 20 |
AFUE | 80 |
AHRI - Usage | Indoor AHU |
Air Flow Direction | Downflow |
BTU Input | 72000 |
BTU Input | 72000 |
BTU Output | 57600 |
Blower Motor HP | 1/2 HP |
Blower Motor Speeds | 4 (Four) |
Blower Motor Type | PSC (Permanent Split Capacitor) |
Blower Wheel Diameter | 11" |
Blower Wheel Width | 8" |
Brand | Frigidaire |
CFM | 1600 |
Cabinet Width | 17.5 |
Country of Origin | USA |
Cubic Measurement | 12.5 |
Cycle/Hertz | 50/60 Hz |
Dimensional Weight | 156 |
Draft Inducer Speeds | 1 (Single) |
ETL Listed | No |
Energy Star Rated | No |
Equipment Type | Furnace |
FER Compliant | No |
Filter Size | No Filter Included |
Fuel Type | Natural Gas |
Full Load Amps | 8.2 |
Furnace Type | Gas |
Gas Connection Size | 1/2" |
Gas Connection Type | NPT |
Heating Stages | Single Stage |
Ignition Type | Hot Surface (HSI) |
Includes Filter Rack | No |
Maximum Overcurrent Protection (MOCP) | 15 |
Package Height | 36 |
Package Length | 30 |
Package Weight | 114 |
Package Width | 20 |
Phase | Single |
Prop 65 | Yes |
Rated Load Amps (RLA) | 8.2 |
Substantial Commodity | Steel; Copper; Aluminum |
Thermal Efficiency | 80% |
UL Listed | No |
Voltage | 115 VAC |