Frigidaire FG7S Series Gas Furnace - 80% Upflow/Horizontal - 126K BTU - 4-5 Ton - D Cabinet
Description
Specifications
Description
Standard Features:
- 100% fired and tested: All units and each component are tested on the manufacturing line.
- Best packaging in the industry: Unique corner post design assures product will arrive to the homeowner dent free.
- 30 second blower delay at start-up assures a warm duct temperature at furnace start-up. Adjustable blower off settings (60, 90, 120 and 180 seconds).
- 30 second post purge increases life of heat exchanger.
- Hot surface igniter: Innovative application of a silicon nitride type igniter. Utilizes proven Smartlite® technology.
- Color coded wire harness: Designed to fit the components, all with quick-connect fittings for ease of service and replacement.
- Flexible category IV venting system: May be vertically or horizontally vented using either a one-pipe or two-pipe system for maximum flexibility in installation.
- High Static Blowers: All models equipped with high static blowers.
- Low Boy Height: Easy to apply in low ceiling applications, works well with taller high SEER coils, easier to handle and install.
- Tubular primary heat exchanger: Heavy gauge aluminized steel heat exchanger and stainless steel secondary heat exchanger assures a long life.
- 90 second fixed cooling cycle blower-off delay (TDR) increases cooling performance when matched with a NORDYNE coil.
- High efficiency blower kits maximize efficiencies. On select units, a SEER improvement of up to 1 point is realized.
- Multi-speed direct drive blower: Designed to give a wide range of cooling capacities. Switches on PCB, provide ultra easy motor speed selection.
- LP convertible: Simple burner orifice and regulator spring change for ease of convertibility.
- Diagnostic lights for easy troubleshooting without counting flashes: Dedicated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes.
- Incorporates integrated control board with connections for electronic air cleaner, humidifier, and twinning.
- Two piece door design enhances furnace appearance and uses captured screws to prevent losing door screws.
- Blower Compartment: Sealed door to reduce air leakage and insulated for ultra quiet operation.
- Sealed Vestibule reduces burner and inducer sound levels.
California residents: see Proposition 65 Warning
Documents
picture_as_pdf consumer literature
picture_as_pdf consumer literature
picture_as_pdf consumer literature
picture_as_pdf installation instructions
picture_as_pdf parts list
picture_as_pdf specification sheet
picture_as_pdf warranty document
picture_as_pdf wiring diagrams
Specifications
Weight | 147 |
---|---|
Height | 36 |
Length | 30 |
Width | 27 |
AFUE | 80 |
AHRI - Usage | Indoor AHU |
Air Flow Direction | Upflow / Horizontal |
BTU Input | 126000 |
BTU Input | 126000 |
BTU Output | 100800 |
Blower Motor HP | 1 HP |
Blower Motor Speeds | 4 (Four) |
Blower Motor Type | PSC (Permanent Split Capacitor) |
Blower Wheel Diameter | 11" |
Blower Wheel Width | 10" |
Brand | Frigidaire |
CFM | 2010 |
Cabinet Width | 24.5 |
Country of Origin | USA |
Cubic Measurement | 16.875 |
Cycle/Hertz | 50/60 Hz |
Dimensional Weight | 210 |
Draft Inducer Speeds | 1 (Single) |
ETL Listed | No |
Energy Star Rated | No |
Equipment Type | Furnace |
FER Compliant | No |
Filter Size | No Filter Included |
Fuel Type | Natural Gas |
Full Load Amps | 13.75 |
Furnace Type | Gas |
Gas Connection Size | 1/2" |
Gas Connection Type | NPT |
Heating Stages | Single Stage |
Ignition Type | Hot Surface (HSI) |
Includes Filter Rack | No |
Maximum Overcurrent Protection (MOCP) | 20 |
Package Height | 36 |
Package Length | 30 |
Package Weight | 147 |
Package Width | 27 |
Phase | Single |
Prop 65 | Yes |
Substantial Commodity | Steel; Copper; Aluminum |
UL Listed | No |
Voltage | 115 VAC |